TM 5-3805-290-23-2
FRONT WINDSHIELD WIPER AND MOTOR REPLACEMENT - CONTINUED
0119 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and other sources of ignition. Failure to do so may result in injury or
death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when dry-
ing parts with compressed air. DO NOT direct compressed air against human skin. Make sure air stream is
directed away from user and other personnel in the area. To prevent injury, user must wear protective goggles
or face shield. Failure to follow this warning may result in injury to personnel.
1.
Clean all metal parts and surfaces with solvent cleaning compound (do not use solvent on motor).
2.
Dry parts with compressed air.
3.
Inspect all parts for damage, wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
1.
Install wiper motor assembly (31) on machine.
N OT E
Support wiper motor assembly from inside cab.
2.
Install plate (29) and new gasket (30) on machine.
3.
Install two washers (28) and nuts (27) on wiper motor shafts (24). Tighten nuts to 14 0.7 lb-ft (19 1 Nm).
4.
Install torx screw (25) on plate (26).
5.
Install two plastic caps (23) on wiper motor shafts (24).
0119 00-7
