TM 5-3805-291-10
HIGHWAY TRANSPORT - CONTINUED
0019 00
UNLOADING MACHINE FROM TRAILER - CONTINUED
0019 00
5.
Remove vandalism protection devices.
6.
Remove tape from exhaust opening.
WARN I N G
DO NOT operate machine with steering frame lock connected. Steering frame lock must be disconnected
and securely stowed. If not properly stowed, loss of steering control could result. Failure to follow this
warning may result in injury or death to personnel or damage to equipment.
7.
Disconnect and securely stow steering frame lock (WP 0015 00).
8.
Turn battery disconnect switch to ON position (WP 0004 00).
9.
Turn engine start switch to ON position and leave it there for 30 seconds.
10.
Turn engine start switch to OFF position and leave it there for 30 seconds.
11.
Turn engine start switch to ON position and leave it there for 30 seconds.
WARN I N G
Stand clear of frame articulation area when machine is operating. There is no clearance for personnel in
this area when machine turns. Crushing could occur, resulting in injury or death to personnel.
12.
Start engine and allow to warm up (WP 0005 00).
13.
Press bottom of hydraulic lockout (IMPLEMENT DISABLE) switch to unlock hydraulic controls (WP 0004 00).
14.
Raise loader arm as required so that loader arm will clear crest of trailer ramp (WP 0004 00). Remove blocking from
under work tool.
WAR N I N G
Always use a ground guide when operating machine down ramp to unload from trailer. Failure to use a
ground guide may cause injury or death to personnel or damage to equipment.
When operating machine without ROPS/FOPS, drive with extreme caution, at low idle, and in 1st gear reverse
ONLY. Machine has no rollover/falling object protection without ROPS/FOPS. Failure to follow this warning
may cause injury or death to personnel or damage to equipment.
15.
Using ground guide assistance and in 1st gear ONLY, SLOWLY drive straight off trailer until clear of ramp.
16.
Park machine in staging area clear of trailer (WP 0005 00).
17.
Shut down engine (WP 0005 00).
18.
Turn battery disconnect switch to OFF position (WP 0004 00).
19.
Install four sets of plugs (Items 6 and 7, Table 2, WP 0026 00) on electrical connectors and install tarp (Items 1 and 10,
Table 2, WP 0026 00) to protect cab.
0019 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION
Refer to WP 0024 00.
END OF WORK PACKAGE
0019 00-4