TM 5-3805-291-10
CONFIGURE MACHINE FOR TRANSPORT - CONTINUED
0024 00
INTRODUCTION - CONTINUED
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure any lifting device used is in good condition and of lifting capacity. Keep clear of heavy parts
supported only by lifting device. Failure to follow this warning may result in injury or death to personnel.
3.
Components removed and installed during this procedure are very heavy. Use assistance, caution, and follow safe work
practices when handling them. Lifting equipment available at the staging area must be used.
TOOLS AND EQUIPMENT
1.
Tools and equipment required to prepare the machine for transport are:
a.
stowed in BII box on machine (Table 2, WP 0026 00);
b.
provided by Unit Maintenance (general mechanic's tool kit, common no. 1 shop equipment, and field maintenance
shop equipment); and
c.
1,500-lb capacity lifting equipment.
2.
Reinstall mounting hardware for all removed components on machine to secure against loss during transport.
ROPS/FOPS REMOVAL
0024 00
N OT E
Tag electrical harnesses and hoses as they are disconnected to ensure correct connection.
Work tool must be removed prior to cab removal.
1.
Place transmission switch in manual mode.
2.
Turn engine start switch to OFF position (WP 0004
3.
Remove fire extinguisher and secure with BII.
4.
Disconnect four connectors (three electrical and one
coaxial) (1) at right-rear corner of cab.
5.
Install three sets of plugs (Items 6 and 7, Table 2, WP
0026 00) on electrical connectors in cab and on ROPS.
6.
Close and secure right-side window.
0024 00-2