TM 5-3805-291-23-1
TROUBLESHOOTING INTRODUCTION - CONTINUED
0004 00
GENERAL INFORMATION - CONTINUED
Glossary - Continued
36.
Full Load Setting (FLS). FLS is a number that represents fuel system adjustment. This adjustment is made at factory in
order to fine tune fuel system. Correct value for this parameter is stamped on engine information ratings plate. This
parameter must be programmed.
37.
Full Torque Setting (FTS). FTS is similar to full load setting. Parameter must be programmed.
38.
Harness. Harness is a bundle of wiring (loom) that connects all electronic system components.
39.
Hertz (Hz). Hertz measures electrical frequency in cycles per second.
40.
Intake Manifold Temperature Sensor. This sensor detects intake manifold temperature. ECM monitors intake mani-
fold temperature and other data in order to adjust injection timing and other performance functions.
41.
Integrated Electronic Controls. Engine is designed with electronic controls as necessary part of system. Engine will
not operate without electronic controls.
42.
J1939 CAN Data Link. Data link is an SAE diagnostic communications data link used to communicate between elec-
tronic engine and instrument clusters.
43.
Logged Diagnostic Codes. Logged diagnostic codes are codes stored in memory. These codes are meant to be an indi-
cator of possible causes for intermittent problems. Refer to Diagnostic Code in this glossary for more information.
44.
Open Circuit. An open circuit is a condition caused by an open switch or a broken electrical wire or connection. When
this condition exists, signal or supply voltage can no longer reach its intended destination.
45.
Parameter. A parameter is a value or limit programmable. This helps determine specific engine characteristics or
behaviors.
46.
Password. A password is a group of numeric or alphanumeric characters designed to restrict access to parameters. Elec-
tronic system requires correct passwords in order to change some parameters (Factory Passwords).
47.
Personality Module. This module is attached to inside of ECM. Module contains all instructions (software) for ECM
and performance maps for a specific horsepower family. Personality module may be reprogrammed through flash pro-
gramming.
48.
Power Cycle. Power cycle happens when power to ECM is cycled: ON, OFF, and ON. Power cycle refers to action of
cycling engine start switch from any position to OFF position and to START/RUN position.
0004 00-5
