TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) At sensor wiring harness connector,
1. If resistance is greater than 5,000 Ohms,
0177 04 - Continued.
measure resistance between signal
repeat this procedure again. If failure is
contact 1 (wire R818-YL) and frame
not found, replace powertrain ECM
ground.
(WP 0063 00).
2. If resistance is less than 5,000 Ohms,
there is a short between frame ground
and signal circuit in the wiring harness.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-11