TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Part number of powertrain ECM.
1. If all part numbers are correct, go to Test
0596 02 - Continued.
2.
2. If all part numbers are not correct, part
number of powertrain ECM or
implement ECM may be incorrect.
Incorrect configuration software may
also be installed. Replace incorrect
ECM with an ECM that has correct part
number. Flash correct configuration
software (WP 0056 00, WP 0057 00,
WP 0060 00, and WP 0063 00).
2. Inspect harness connections.
(a) Turn battery disconnect switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect and inspect all wiring
harness connections related to CAT
Data Link (WP 0237 00). Make sure
connectors are clean and tight. Refer to
Electrical Connectors Inspection (WP
0022 00) as necessary.
(c) Check connectors for proper mating.
(d) Check wires at connector.
(e) Check each wire for nicks or signs of
abrasion in insulation.
(f) Check for moisture at connector.
(g) Check connectors for dirty or corroded
contacts.
(h) Check each pin and socket of
powertrain harness connectors.
(i) Reconnect all connectors.
1. If powertrain harness connectors are
tightly connected and free of corrosion,
go to Test 3.
2. If powertrain harness connectors are in
need of repair, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for shorts to ground.
(a) Turn battery disconnect switch to OFF
position (TM 5-3805-291-10).
0009 00-48