TM 5-3805-291-23-2
MESSENGER ECM REPLACEMENT - CONTINUED
0056 00
FLASH PROGRAMMING - CONTINUED
N OT E
If flash programming the ECM as directed by troubleshooting, proceed to step 12. If replacing an ECM,
proceed to Copy Configuration (Program ECM) in this work package.
12.
Start engine. Run until operating temperature is reached and verify proper operation of all components (TM 5-3805-
291-10). Check for active diagnostic codes (WP 0006 00).
COPY CONFIGURATION (PROGRAM ECM)
0056 00
1.
Highlight the ECM, then click "OK".
2.
Ensure the correct ECM is highlighted. Select "Copy Configuration" from the "Service" menu, then select "ECM
replacement" from the sub-menu.
3.
Highlight configuration file that was saved earlier and double click to open. "The current ECM Replacement data came
from..." dialogue box opens. Select "OK".
4.
Select "Program ECM" push-button, then highlight the ECM to be programmed and click "OK".
5.
Read the "Warning! This configuration is for the control..." message and verify that the Equipment ID appears, then
select "Yes" to "Program the ECM".
6.
If the "Programming parameter cannot be programmed..." message appears, select "OK".
7.
Close the "Programming complete..." dialogue box by selecting "OK".
8.
The "Programming parameter cannot be programmed..." message will reappear. Then select "OK".
9.
Start engine. Run until operating temperature is reached and verify proper operation of all components (TM 5-3805-
291-10). Check for active diagnostic codes by selecting "Active Diagnostic Codes" from the "Diagnostics" menu (WP
0006 00).
10.
Disconnect ET (WP 0005 00).
END OF WORK PACKAGE
0056 00-6
