TM 5-3805-291-23-2
BRAKE ACCUMULATOR MAINTENANCE - CONTINUED
0114 00
WARN I N G
DO NOT disconnect or remove any hydraulic systemline or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escaping
hydraulic fluid under pressure can penetrate the skin, causing injury to personnel.
At operating temperature, hydraulic oil is hot. Alow hydraulic oil to cool before disconnecting any
hydraulic lines. Failure to follow this warning may result in injury to personnel.
The accumulator is filled with dry nitrogen. DO NOT loosen or remove the valve or cap from the top of
the accumulator. Failure to follow this warning may result in injury to personnel.
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and hoses and plug
openings after removing lines. Contamination of system could result in premature failure.
N OT E
Tag hoses prior to removal to ensure correct installation.
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local pol-
icy and ordinances. Ensure all spills are cleaned up.
REMOVAL
N OT E
Accumulators for both front and rear service brakes are located behind ladder on right side of machine.
1.
Remove two bolts (1) and washers (2) from door (3).
Open door.
427-C0142
0114 00-2
