TM 5-3805-291-23-2
REAR WINDSHIELD WIPER AND MOTOR REPLACEMENT - CONTINUED
0146 00
INSTALLATION CONTINUED
CAU T I ON
Push wiper arm assembly straight onto tapered shaft. If wiper arm assembly is not installed properly,
when shaft turns, splines will be improperly formed and damage will occur.
6.
Position wiper arm assembly (8) on tapered shaft 4.3 1.6 in. (110 40 mm) from lower edge of glass. Tighten bolt (7)
to 15 2 lb-ft (20 3 Nm).
CAU T I ON
DO NOT use petroleum lubricants on hose ends. DO NOT stretch hose between connection points.
This will cause damage to hose.
7.
Connect hose (6) to wiper arm assembly (8).
8.
Install interior panel (3), two screws (2), and three screws (1) on machine.
427-C0244
9.
Verify proper operation of rear windshield wiper (TM 5-3805-291-10).
END OF WORK PACKAGE
0146 00-6