TM 5-3805-291-23-2
TILT CYLINDERS REPLACEMENT - CONTINUED
0152 00
REMOVAL - CONTINUED
6.
Remove eight bolts (13) and washers (14) from four
flange halves (15).
7.
Disconnect hose assemblies (4 and 11) and remove
two O-rings (16) and hose assemblies from machine.
Discard O-rings.
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure any lifting equipment used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting equipment. Failure to follow this warning may result in injury or
death to personnel.
N OT E
Tilt cylinder weighs 485 lb (220 kg).
Tooling weighs 150 lb (68 kg) and consists of a hand-driven hydraulic pump, hydraulic puller, plain
stud, nut, washer, and pin inserter/remover.
8.
Attach lifting equipment to tilt cylinder (6).
427-C0535
0152 00-5