TM 5-3805-291-23-2
SEPARATE FRONT LOADER FRAME AND REAR FRAME - CONTINUED
0211 00
CONNECTION
N OT E
Apply antiseize compound to all bores when connecting frames. Lubricate all pin bores, seals, and pins
with grease before installation.
The following steps are for assembling lower hitch bearings.
1.
Position cap (34) and install four washers (36) and
bolts (35) equally spaced on cap. Ensure cap is seated
firmly against frame of machine.
2.
Lower temperature of lower bearing cup (41) and use
Bushing driver set (Item 19, WP 0232 00) to install so
lower bearing cup makes contact with cap (34).
3.
Apply clean oil to new lower bearing (43) and install
in new lower bearing cup (41).
4.
Apply clean oil to new upper bearing (42) and install
next to lower bearing (43).
5.
Lower temperature of new upper bearing cup (40) and
use Bushing driver set (Item 19, WP 0232 00) to
install so upper bearing cup makes contact with upper
427-C1024
bearing (42).
6.
Remove four bolts (35) and washers (36) from cap
(34).
7.
Remove cap (34) from machine.
8.
Position shims (37) on lower hitch (15).
9.
Install caps (33 and 34), four washers (36), and bolts
(35) on lower hitch (15).
10.
Install 1/4 NC x 3 3/4-in. bolt, two 1/4 NC nuts, and
two driver plates. Use torque wrench to measure roll-
ing torque. Adjust number of shims (37) to achieve
rolling torque of 70 to 204 lb-in. (8 to 23 Nm).
11.
Remove four bolts (35) and washers (36) from caps
(33 and 34).
12.
Remove caps (33 and 34) from machine.
427-C1050
0211 00-11