TM 5-3805-291-23-2
WINDSHIELD FRONT/REAR AND DOORS GLASS REPLACEMENT - CONTINUED
0213 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for damage, wear, pitting, and splits and replace if necessary.
INSTALLATION
1.
Install new seal on machine.
2.
Install rope inside channel around perimeter of seal
(2), with ends of rope overlapping.
427-C1450
3.
With assistance, position windshield (1) on machine.
4.
With another person applying pressure to outside of
windshield (1), slowly pull rope from inside cab as
seal (2) seals around perimeter of glass opening. Pres-
sure should be uniformly applied around windshield
as rope is being pulled from seal.
427-C1451
5.
Repeat steps 1 thru 4 for remaining glass sections.
END OF WORK PACKAGE
0213 00-3/(0213 00-4 Blank)
