TM 5-3805-292-10
0008
INSTALLATION
0008
1. Ensure BII compartment door is closed and locked.
2. Start engine. Refer to Starting Engine in WP 0005.
3. Tilt attachment coupler (Figure 5, Item 1) with top forward and slowly drive machine forward until top of attach-
ment coupler fits under cover lifting bracket (Figure 5, Item 2). Refer to Operating Machine (WP 0005).
4. Raise loader arms to engage top of attachment coupler (Figure 5, Item 1) into cover lifting bracket (Figure 5,
Item 2). Refer to Operating Loader (WP 0005).
NOTE
Operator can not exit machine during this step due to partially raised loader arm blocking
door.
5. Tilt attachment coupler (Figure 5, Item 1) back so that attachment coupler and lower latch bar (Figure 5,
Item 4) are in full contact. With assistance, engage manual locking levers (Figure 5, Item 5). Refer to Operating
Loader in WP 0005.
WARNING
Personnel must stand clear of container cover while it is raised. Failure to follow this
warning may result in injury or death to personnel or damage to equipment.
6. Carry cover (Figure 5, Item 3) low to ground.
7. Raise loader arms until cover (Figure 5, Item 3) clears tools and ease machine forward. Refer to Operating
Machine in WP 0005.
8. With assistance, lower loader arms slowly while aligning cover (Figure 5, Item 3) over tools inside container
until cover is seated.
9. With assistance, disengage manual locking levers (Figure 5, Item 5).
10. Lower loader arms until attachment coupler (Figure 5, Item 1) clears cover lifting bracket (Figure 5, Item 2) and
slowly back machine away. Refer to Operating Machine (WP 0005)
0008-4
