TM 5-3805-292-23
0009
Table 1. Preventive Maintenance Checks and Services (PMCS) .
LOCATION
ITEM TO
CHECK/
ITEM
MAN-
NOT FULLY MISSION
SERVICE
NO.
INTERVAL
HOURS
PROCEDURE
CAPABLE IF:
N OT E
Review all WARNINGs, CAUTIONs, and NOTEs before
performing PMCS on the M400T or M400W Skid Steer
Loader.
Unless otherwise indicated, perform all preventive
maintenance and lubrication with machine parked on
level ground, engine shut down, parking brake engaged,
and hydraulic system pressure relieved.
Perform Operator PMCS prior to or in conjunction with
Field PMCS if:
There is a delay between daily operation of the
machine and Field PMCS.
The regular operator is not assisting.
WARN I N G
Engine Oil
Contact with engine/hydraulic oil can damage skin.
Wear gloves when handling engine/hydraulic oil. If oil
contacts skin, wash it off immediately. Failure to follow
this warning may result in injury to personnel.
1
Initial 50
1.0
Replace engine oil and filter (WP
Hours
Auger
2
Initial 50
1.0
a. Remove drive from mounting
Hours
bracket (WP 0167).
b. Remove drain/fill plug and drain
lubricant from drain/fill opening.
c. Install drive on mounting bracket
d. Tilt drive down 15 degrees from
horizontal and support with wood
blocks. Add 80W or 90W lubricant
through drain/fill opening until
lubricant covers internal gear.
0009-2
