6
TM 5-3805-292-23
FIELD MAINTENANCE
-
AUGER REPAIR
0
167
REMOVAL, CLEANING AND INSPECTION, INSTALLATION
INITIAL SETUP
References
Tools and Special Tools
0
0
Tool Kit, General Mechanic's (WP 0178, Item
TM 5-3805-292-23P, Figure 75
0
33)
0
Equipment Conditions
0
Wooden Blocks
0
Machine parked on level ground (TM 5-3805-
Materials/Parts
292-10)
0
0
Cap Set, Protective (WP 0179, Item 2)
0
Estimated Time to Complete
0
Cleaning Compound, Solvent, Type III (WP
1.5 Hr
0179, Item 3)
0
0
Rag, Wiping (WP 0179, Item 19)
0
O-ring (2)
0
WARN I N G
Lubricating/hydraulic oils used in the perfomance of maintenance can be very slippery.
r
Immediately wipe up any spills.
When servicing this machine, performing mainenance, or disposing of materials such as
t
engine coolant, hydraulic fluid, lubricants, battery acids or batteries, and CARC paint,
consult your unit/local hazardous waste disposal center or safety office for local regulatory
guidance. If further information is needed, please contact The Army Environmental Hotline
at 1-800-872-3845.
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and
hoses and plug openings after removing lines. Contamination of system could result in
premature failure.
0167-1