TM 5-3805-292-23
0032
END OF TASK
CLEANING AND INSPECTION
00032
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and
low toxic material. However, it may be irritating to the eyes and skin. Use protective gloves
and goggles. Use in well-ventilated areas. Keep away from open flames and other
sources of ignition. Failure follow this warning may result in injury or death to personnel.
1. Clean all parts (except rubber and plastic surfaces) and mating surfaces with solvent cleaning compound.
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
2. Dry parts with compressed air.
3. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00032
N OT E
Lubricate oil filter seal with a light coat of clean engine oil.
1. Fill new engine oil filter (Figure 2, Item 2) with clean engine oil.
2. Turn engine oil filter (Figure 2, Item 2) clockwise to install on engine oil filter base (Figure 2, Item 1).
3. Tighten engine oil filter (Figure 2, Item 2) until seal contacts base, then tighten an additional 3/4 to 1 full turn.
4. Install right side access cover (Figure 1, Item 2) onto machine and tighten two thumb screws (Figure 1, Item 1).
END OF TASK
FOLLOW-ON TASKS
00032
Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0032-3/(4 blank)
