TM 5-3805-292-23
0063
CLEANING AND INSPECTION
00063
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and
low toxic material. However, it may be irritating to the eyes and skin. Use protective gloves
and goggles. Use in well-ventilated areas. Keep away from open flames and other
sources of ignition. Failure follow this warning may result in injury or death to personnel.
1. Clean all parts (except rubber surfaces) and mating surfaces with solvent cleaning compound.
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
2. Dry parts with compressed air.
3. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00063
1. Install isolation block (Figure 2, Item 17) on tube assemblies (Figure 2, Items 9 and 10).
N OT E
Lubricate new O-ring with hydraulic oil.
2. Position new O-ring (Figure 2, Item 14) on hose (Figure 2, Item 13) and connect hose to lower tube assembly
(Figure 2, Item 10).
3. Position new O-ring (Figure 2, Item 14) on hose (Figure 2, Item 13) and connect hose to upper tube assembly
(Figure 2, Item 9).
4. Position fitting (Figure 2, Item 11) on machine and connect lower tube assembly
(Figure 2, Item 10) to fitting.
5. Tighten fitting (Figure 2, Item 11).
6. Position fitting (Figure 2, Item 12) on machine and connect upper tube assembly (Figure 2, Item 9) to fitting.
7. Tighten fitting (Figure 2, Item 12).
8. Position bracket (Figure 2, Item 8) on tube assemblies (Figure 2, Items 9 and 10).
9. Position two clamps (Figure 2, Item 15) on isolation block (Figure 2, Item 17).
10. Install two washers (Figure 2, Item 7), bolts (Figure 2, Item 6), and nuts (Figure 2, Item 16) on bracket
(Figure 2, Item 8) and clamps (Figure 2, Item 15).
11. Position bracket (Figure 2, Item 8) on machine and install two washers (Figure 2, Item 3) and bolts (Figure 2,
Item 2).
0063-4
