TM 5-3805-292-23
0097
CLEANING AND INSPECTION CONTINUED
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
2. Dry parts with compressed air.
3. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00097
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported only by lifting
equipment. Failure to follow this warning may result in injury or death to personnel.
N OT E
Counterweight bumper weighs 127 lb (58 kg).
1. Use lifting device to install two nuts (Figure 1, Item 4), counterweight bumper (Figure 1, Item 3), two washers
(Figure 1, Item 2), and bolts (Figure 1, Item 1) on machine.
2. Remove lifting device from counterweight bumper (Figure 1, Item 3).
END OF TASK
FOLLOW-ON TASKS
00097
1. Close rear access door (TM 5-3805-292-10).
2. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0097-3/(4 blank)