TM 5-3805-298-23-1
0035
Table 1. Engine Cranks But Does Not Run.
0035
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
Engine Cranks But Does Not
Run
Always inspect wiring harness connectors that are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Check for Active Event
or Diagnostic Codes.
Connect MSD, select C6.6 924, and
Event or Diagnostic Codes Are Not
Active - Proceed to Test Step 2.
check for active event or diagnostic
codes (WP 0008).
Event Code E0265 Active - Proceed
to Test Step 11.
Other Event or Diagnostic Code(s)
Are Active - Refer to (WP 0005) and
repair other active event or diagnostic
codes first.
