TM 5-3805-298-23-1
0052
Table 1. 168 Electrical System Voltage Diagnostic Codes - Continued.
052
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
168-2 Electrical System
Test Step 10. Test Voltage of Battery
Voltage Erratic, Intermittent,
Supply Circuits at Engine ECM.
1. Connect connector EN-C2
or Incorrect - Continued
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
Voltage 18 to 26 V Proceed to step 4.
(WP 0174), test for voltage
Voltage Less Than 18 V Replace
engine wiring harness (WP 0299).
Figure 11) terminal 7 and ground.
Proceed to Test Step 11.
Voltage 18 to 26 V Proceed to step 5.
(WP 0174), test for voltage
Voltage Less Than 18 V Replace
engine wiring harness (WP 0299).
Figure 11) terminal 8 and ground.
Proceed to Test Step 11.
Voltage 18 to 26 V Proceed to step 6.
(WP 0174), test for voltage
Voltage Less Than 18 V Replace
engine wiring harness (WP 0299).
Figure 11) terminal 15 and ground.
Proceed to Test Step 11.
Voltage 18 to 26 V Replace engine
ECM (WP 0265).
(WP 0174), test for voltage
Proceed to Test Step 11.
Figure 11) terminal 16 and ground.
Voltage Less Than 18 V Replace
engine wiring harness (WP 0299).
Proceed to Test Step 11.
Test Step 11. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install right and left engine access
panel (WP 0348).
3. Install right lower cab access
panels (WP 0347).
4. Start engine (TM 5-3805-298-10).
Diagnostic Code 168-2 Electrical
Using MSD, check for active
System Voltage Erratic, Intermittent,
or Incorrect Becomes Inactive
Troubleshooting complete.
Diagnostic Code 168-2 Electrical
System Voltage Erratic, Intermittent,
or Incorrect Remains Active Repeat
troubleshooting from the beginning.
END OF WORK PACKAGE
0052-15/(16 blank)