TM 5-3805-298-23-1
0089
Table 1. 368 Auto-Shift Rocker Switch Diagnostic Codes - Continued.
089
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Remove connector HN-C6
368-3 Auto-Shift Switch
(WP 0012, Figure 67) from
Voltage Is Above Normal -
autoshift switch (WP 0012,
Continued
Figure 68).
4. Push autoshift switch to OFF
(manual) position (TM 5-3805-298-
10).
5. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 6.
between autoshift switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 68) terminal 1
Replace autoshift switch (WP 0257).
and terminal 2.
Proceed to Test Step 8.
6. Push autoshift switch to AUTO
position (TM 5-3805-298-10).
7. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 8.
between autoshift switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 68) terminal 3
Replace autoshift switch (WP 0257).
and terminal 2.
Proceed to Test Step 8.
8. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 9.
between autoshift switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 68) terminal 4
Replace autoshift switch (WP 0257).
and terminal 5.
Proceed to Test Step 8.
9. Push autoshift switch to AUTO 1
position (TM 5-3805-298-10).
10. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to step 11.
between autoshift switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 68) terminal 3
Replace autoshift switch (WP 0257).
and terminal 2.
Proceed to Test Step 8.
11. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 3.
between autoshift switch
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 68) terminal 6
Replace autoshift switch (WP 0257).
and terminal 5.
Proceed to Test Step 8.
0089-3