TM 5-3805-298-23-1
0089
Table 1. 368 Auto-Shift Rocker Switch Diagnostic Codes - Continued.
089
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
Continuity - Replace autoshift switch
368-4 Auto-Shift Switch
(WP 0174), test for continuity
(WP 0257).
Voltage Is Below Normal -
between autoshift switch
Continued
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 3
No Continuity - Proceed to step 6.
and terminal 2.
6. Using digital multimeter
Continuity - Replace autoshift switch
(WP 0174), test for continuity
(WP 0257).
between autoshift switch
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 5
No Continuity - Proceed to step 7.
and terminal 6.
7. Push autoshift switch to AUTO
position (TM 5-3805-298-10).
8. Using digital multimeter
Continuity - Replace autoshift switch
(WP 0174), test for continuity
(WP 0257).
between autoshift switch
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 1
No Continuity - Proceed to step 9.
and terminal 2.
9. Using digital multimeter
Continuity - Replace autoshift switch
(WP 0174), test for continuity
(WP 0257).
between autoshift switch
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 5
No Continuity - Proceed to step 10.
and terminal 6.
10. Push autoshift switch to AUTO 1
position (TM 5-3805-298-10).
11. Using digital multimeter
Continuity - Replace autoshift switch
(WP 0174), test for continuity
(WP 0257).
between autoshift switch
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 1
No Continuity - Proceed to step 12.
and terminal 2.
12. Using digital multimeter
Continuity - Replace autoshift switch
(WP 0174), test for continuity
(WP 0257).
between autoshift switch
Proceed to Test Step 11.
(WP 0012, Figure 68) terminal 4
No Continuity - Proceed to Test Step 3.
and terminal 5.
Test Step 3. Test for Shorted Wiring
Harness for Circuit Auto and Manual.
1. Remove left lower cab access
panels (WP 0347).
2. Remove transmission ECM cover
(WP 0266).
3. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
0089-8