TM 5-3805-298-23-1
0106
Table 1. 811 Instrument Cluster Display Module Diagnostic Codes - Continued.
0106
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Remove transmission ECM cover
811-9 Instrument Cluster
(WP 0266).
Display Module
Communication Abnormal
6. Disconnect connector C-C13
Update Rate - Continued
(WP 0012, Figure 25) from
Transmission ECM J2.
7. Using digital multimeter
Resistance 2.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 3.
between connector C-C13
Resistance Greater Than 2.0 Ohms -
(WP 0012, Figure 25) terminal 67
Replace lower cab wiring harness
and terminal 68.
(WP 0291).
Proceed to Test Step 4.
Test Step 3. Test Lower Cab Wiring
Harness for Short.
1. Remove jumper wire from terminal
19 and terminal 20 of connector C-
C56 (WP 0012, Figure 46).
2. Disconnect connector C-C55 from
CAN1 resistor (WP 0012,
Figure 27).
3. Remove right engine access panel
(WP 0348).
4. Disconnect connector EN-C5 from
CAN2 resistor (WP 0012,
Figure 20).
5. Remove right rear lower cab
access panel (WP 0347).
6. Disconnect connector EN-C8 from
C-C19 (WP 0012, Figure 22).
7. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 67
No Continuity - Proceed to step 9.
and terminal 68.
8. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 67
No Continuity - Proceed to step 9.
and ground.
9. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 67
No Continuity - Replace instrument
and all other C-C13 terminals.
cluster (WP 0252).
Proceed to Test Step 4.
0106-3