TM 5-3805-298-23-1
0107
Table 1. 826 Torque Converter Oil Temperature Sensor Diagnostic Codes - Continued.
0107
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector P-C9
826-3 Torque Converter Oil
(WP 0012, Figure 109) from torque
Temperature Sensor Voltage
converter temperature sensor.
Is Above Normal or Shorted
4. Turn battery disconnect switch and
High - Continued
ignition switch to ON position
(TM 5-3805-298-10).
5. Using digital multimeter
Voltage 4.5 to 8 V - Replace torque
(WP 0174), test for voltage
converter temperature sensor
between connector P-C9
(WP 0249).
(WP 0012, Figure 109) terminal 1
Proceed to Test Step 8.
and 2 (ground).
Voltage Not 4.5 to 8 V - Proceed to Test
Step 3.
Test Step 3. Test for Open Wiring
Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Connect jumper wire between
terminal 1 and terminal 2 of
connector P-C9 (WP 0012,
Figure 109).
3. Remove transmission ECM cover
(WP 0266).
4. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
5. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 6.
between connector C-C12
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 26) terminal 29
Proceed to Test Step 4.
and terminal 13.
Test Step 4. Test for Open
Transmission Wiring Harness.
1. Remove right lower cab access
panels (WP 0347).
2. Disconnect connector P-C1
(WP 0012, Figure 53) from
connector C-C15 (WP 0012,
Figure 52).
3. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 5.
between connector P-C1
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 53) terminal 22
Replace transmission wiring harness
and terminal 19.
(WP 0298).
Proceed to Test Step 8.
0107-3