DISASSEMBLY AND ASSEMBLY
REAR AXLE HOUSING REAR SUPPORT
5. Use tool (A) and install the seal in the support.
Make sure the lip of the seal is toward the
outside as shown. Put clean differential oil on
6. Fasten straps and a hoist to support (4) and put
it in position on the trunnion.
Install washer (5), plate (6) and washer (7) in
the end of the support as shown.
Install cover (8) and the bolts on the end of the
support. Tighten the bolts to a torque of 475 ±
50 N·m (350 ± 37 lb.ft.).
a) install rear axle housing