TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
Table 2. Machine Control System - Continued.
TEST OR INSPECTION
CID FMI CODE
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1402 FMI 05 is active before per-
forming this procedure.
1. If diagnostic code remains active, go to
1. Check clutch 2 (forward high) solenoid.
(a) Turn battery disconnect switch and
engine start switch to ON position (TM 2. If diagnostic code is no longer active,
failed. Repeat this test to verify clutch
(b) Disconnect clutch 2 (forward high)
2 (forward high) solenoid failure.
Replace modulating valve (WP 0177
(c) At clutch 2 (forward high) solenoid
00). Verify new transmission control
wiring harness connector, place a
valve corrects problem.
jumper wire from contact 1 (wire 751
GN) to contact 2 (wire R799 BR).
observe status of CID 1402 FMI 05.