TM 5-2420-231-10
0022
PMCS - Continued
Table 1. PMCS - Continued.
ITEM TO BE
EQUIPMENT NOT
CHECKED OR
READY/
ITEM
INTERVAL
SERVICED
PROCEDURE
AVAILABLE IF:
NO.
39
After
Batteries
2. Check battery cables and
a. Cables damaged
(Con't)
mounting hardware for tightness
or cannot be
and corrosion.
tightened.
b. Corrosion cannot
be removed.
40
After
FEL bucket
1. Check for damage, loose or
Any defect that would
missing parts, and secure
prevent operation.
mounting.
NOTE
Use scale on inside back cover of this
manual as a guide when checking
FEL bucket teeth and cutting edge
measurement.
2. Check teeth (WP 0023). If tooth
Any FEL bucket teeth
measurement from back to front
less than 3.5 inches
tip is 3.5 inches (8.9 cm) or less,
(8.9 cm) long.
notify field level maintenance to
replace teeth.
3. Check cutting edges (WP 0023).
Any cutting edge 1
If any cutting edge measurement
inch (2.5 cm) or less.
is 1 inch (2.5 cm) or less, notify
field level maintenance to reverse
or replace cutting edge.
4. Check hoses for chafing and
Class III leaks.
leaks.
41
After
FEL lift arms,
1. Check for damage, loose or
Any defect that would
cylinders, and hoses
missing parts, and secure
prevent operation.
mounting.
2. Check cylinders and hoses for
Class III leaks.
chafing and leaks.
42
After
Front lights/wind-
1. Check for damage, loose or
Any lights necessary
shield wiper
missing parts, and secure
for night operation
mounting.
damaged or missing.
2. Check wiper blade for cracks or
Blade damaged.
tears.
43
After
Fuel tank
Check for damage that would cause
Any fuel leaks or
leaks.
potential fuel leaks.
0022-10