TM 5-3805-255-14
0022
INSTALLATION CONTINUED
00022
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment is in good condition and of
suitable load capacity. Keep clear of heavy parts supported by lifting equipment. Failure to
follow this warning may result in injury or death to personnel.
18. Using suitable lifting device, raise grille-oil cooler-radiator unit into position on loader frame.
19. Work carefully to avoid damage to fan blades or radiator fan housing. Install grille mounting bolts, washers and
nuts. Tighten securely. Remove lifting device.
20. Install lower radiator mounting capscrews into brackets and tighten nuts.
21. Connect electrical wires at rear lamps, stop lamps, and back-up alarm.
22. Connect previously tagged lines to oil cooler. Connect both upper and lower radiator hoses to radiator.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment is in good condition and of
suitable load capacity. Keep clear of heavy parts supported by lifting equipment. Failure to
follow this warning may result in injury or death to personnel.
23. Using a suitable lifting device, raise and install hood on grille and front bulkhead. Line up mounting holes and
install bolts, washers and nuts. Remove lifting device.
24. Install hose between air cleaner and engine air inlet pipe. Tighten hose clamps securely.
25. Connect air compressor air inlet hose to air cleaner.
26. Install extension shaft and air cleaner on air cleaner housing.
27. Install exhaust stack, through hood, on exhaust of turbocharger. Tighten stack clamp securely.
28. Fill radiator with coolant (WP 0018).
29. Fill hydraulic reservoir with fluid (WP 0018).
30. Fill and check engine crankcase oil level (WP 0018).
31. Connect cables to batteries (WP 0045).
32. Start engine and check for leaks at radiator and torque converter connections.
33. With engine idling, check transmission fluid level (WP 0018). Add fluid as needed.
34. Check engine for proper operation (WP 0005).
35. Install engine access panels (WP 0005).
END OF TASK
END OF WORK PACKAGE
0022-6
