TM 5-3805-255-14
0059
ASSEMBLY
00059
NOTE
Lubricate internal actuating parts of brake assembly (wedge assembly, guide screws,
plunger, and actuator cavity) with GAA before assembly.
1. Install seal (Figure 16, Item 6) on plunger (Figure 16, Item 5) until seal lip enters groove in plunger. Slide
plunger into housing (Figure 16, Item 4), aligning groove in plunger with guide screw hole in housing. Seat seal
on housing.
2. Place detent (Figure 16, Item 3), lock (Figure 16, Item 2), and bolt (Figure 16, Item 1) on housing (Figure 16,
Item 4).
3. Tighten bolt (Figure 16, Item 1) and bend lock (Figure 16, Item 2) against bolt.
4. Screw adjustment bolt (Figure 16, Item 7) into plunger (Figure 16, Item 5).
Figure 16. Plunger Assembly.
0059
0059-14