TM 5-3805-255-14
0059
ASSEMBLY CONTINUED
CAUTION
Do not over-tighten cylinder housing. Failure to comply may result in damage to
equipment.
NOTE
If bleeder and brake line holes are not in desired position, unscrew cylinder to align as
desired. This will require less than one full turn.
16. Install wheel cylinder (Figure 21, Item 2) in spider (Figure 21, Item 8).
17. Install lockplug (Figure 21, Item 1) and torque to 175 to 200 lb-in. (19.8 to 22.6 Nm). Loosen lockplug and
torque to 50 lb-in. (5.6 Nm).
18. Install bleeder screw (Figure 21, Item 3) and connect hydraulic line (Figure 21, Item 4) to wheel cylinder
(Figure 21, Item 2).
END OF TASK
0059-18