TM 5-3805-255-14
0065
DISASSEMBLY CONTINUED
CAUTION
Each connecting rod is matched to its own bearing cap. Do not interchange. Before
separating, mark each rod and cap for proper fit and ease of installation. Failure to follow
this caution may result in damage to equipment.
NOTE
One piston is shown; repeat steps 13 through19 for other piston.
13. Remove two bolts (Figure 4, Item 9), locking plate (Figure 4, Item 10), and bearing cap (Figure 4, Item 6) from
connecting rod (Figure 4, Item 5) and crankshaft (Figure 4, Item 8).
14. Remove piston (Figure 4, Item 11) and connecting rod (Figure 4, Item 5) from crankcase (Figure 4, Item 7).
15. Replace bearing cap (Figure 4, Item 5) on connecting rod (Figure 4, Item 5).
16. Remove piston rings (Figure 4, Item 1) from piston (Figure 4, Item 11).
17. Remove wrist pin securing buttons (Figure 4, Item 3) and press wrist pin (Figure 4, Item 2) from piston (Figure
4, Item 11) and connecting rod (Figure 4, Item 5).
18. Remove bearing sleeve (Figure 4, Item 6) from bearing cap and connecting rod (Figure 4, Item 5).
19. Remove wrist pin bushing (Figure 4, Item 4) from connecting rod (Figure 4, Item 5).
Figure 4. Piston.
0065
0065-6
