TM 5-3805-255-14
0089
CLEANING, INSPECTION, AND REPAIR CONTINUED
d. Place new sleeve (Figure 18, Item 1) into sleeve bore in cylinder head (Figure 18, Item 2). Tap sleeve with
a plastic or rawhide hammer until it bottoms.
e. Install Sleeve Bottoming Tool No. PLT-507-4 (Figure 18, Item 3). Tighten hex head nut against spacer of
tool until sleeve comes in firm contact with seat in cylinder head. Top of nozzle sleeve can be slightly below
finished surface of cylinder head but must not protrude above it more than 0.030 in. (0.76 mm).
Figure 18. Injector Nozzle Sleeve Bottoming Tool.
0089
0089-18