TM 5-3805-255-14
0103
DISASSEMBLY CONTINUED
52. Remove output shaft rear seal (Figure 33, Item 2) from bearing retainer (Figure 33, Item 1).
Figure 33. Output Shaft Rear Seal.
0103
END OF TASK
CLEANING AND INSPECTION
000103
Clean and inspect transmission components IAW General Maintenance Instructions (WP 0019). In preparation for
assembly be sure to include following:
1. Clean all parts thoroughly in solvent or steam. Use compressed air to dry parts. If steam is used to clean parts,
oil immediately thereafter. Carefully inspect all parts for excessive wear, cracks, and breakage.
NOTE
If replacement is required, bearing cup and cone must be replaced as a set.
2. Inspect all bearings for pits and spalled areas and replace if necessary.
3. Replace all seals, hook type seal rings, gaskets, O-rings, and snap rings.
4. Inspect all sealing surfaces for wear and for grooving.
5. Inspect housing for dirt particles, and flush all passageways thoroughly.
6. Inspect splines on all shafts and drive gears for wear.
8. Clean and flush oil supply tubes.
END OF TASK
0103-21