TM 5-3805-255-14
0118
DISASSEMBLY
000118
NOTE
Drain excess oil out of cylinder. Disassemble cylinder in a clean area.
1. Use spanner wrench to remove retaining cap (Figure 1, Item 12) from steering cylinder (Figure 1, Item 3).
2. Remove steering rod assembly (Figure 1, Item 11) from steering cylinder (Figure 1, Item 3).
3. Remove nut (Figure 1, Item 4) from threaded end of steering rod assembly (Figure 1, Item 11).
4. Remove piston (Figure 1, Item 5) from steering rod assembly (Figure 1, Item 11).
5. Remove two piston rings (Figure 1, Item 16) and set seals (Figure 1, Item 6) from piston (Figure 1, Item 5).
Discard rings and seals.
6. Remove gland (Figure 1, Item 7), seal (Figure 1, Item 8), and backup ring (Figure 1, Item 9) from steering rod
assembly (Figure 1, Item 11). Discard seal and backup ring.
7. Remove seals (Figure 1, Items 15 and 14) and O-ring (Figure 1, Item 13) from steering rod assembly (Figure 1,
Item 11). Discard seals and O-ring.
8. Remove retaining cap (Figure 1, Item 12) from steering rod assembly (Figure 1, Item 11).
9. Remove two lubrication fittings (Figure 1, Item 2) and set screws (Figure 1, Item 1) from steering rod assembly
(Figure 1, Item 11) and steering cylinder (Figure 1, Item 3).
10. Remove two bushings (Figure 1, Item 10) from steering cylinder (Figure 1, Item 3) and steering rod assembly
(Figure 1, Item 11).
0118-2