TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
ENGINE
RADIATOR AND HYDRAULIC OIL COOLER
Models 950BNSCE and 950BSCE
ASSEMBLE RADIATOR
1.
2.
3.
4.
Place bottom tank (1) in position on wooden
blocks as shown.
If a replacement was necessary, put a seal
strip (2) that is 42.13 in. (107 cm) long in
position in each channel with the side that
has adhesive on it down. Install the bracket
that holds the seal strips in place in the
channels. The seal strips go toward the back
of the radiator.
Install channels (3) and (4) on the bottom
tank. Make sure the seal strips in the channel
are toward the back of the radiator.
Make sure the holes in the bottom tank are
clean. Put liquid soap on the sealing areas and
install seals (5) on the bottom tank.
NOTE: Put the liquid soap on the seals just
before assembly.
5-48j
