POWER TRAINTM 5-3805-258-24-2DISASSEMBLY AND ASSEMBLYAXLESINSTALL AXLES3278-12Tools NeededA2P8312Pliers11.2.3.4.5.6.Make sure the axles are clean and free of dirtand foreign material.Fasten a hoist and put axle (1) in position.Install gear (2) half way on the axle.Put apiece of pipe (3) which has a 5.1 cm (2 in.)outside diameter and 61 cm (24 in.) long in theend of gear (2) as shown. Push down on the pipeand slide the drive axle into position.Remove the pipe. Slide gear (2) into position inthe final drive planetary. Use tool (A) and in-stall ring (4) that holds gear (2) in position onthe axle.Turn the flat sides of the three shafts (5)toward the outside as shown to give clearancefor the counterbore in cover (7).CAUTIONIf the cover does not fit flat up against the finaldrive without force, remove the cover and doStep 6 again.7.8.9.Put clean oil on O-ring seal (6) and install cover(7).Install the O-ring seal on plug (8) and install itin the final drive.Fill the final drives with oil to the correct level.S e e L U B R I C A T I O N A N D M A I N T E-NANCE GUIDE.5-167
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business