TM 5-3805-258-24-2POWER TRAINDISASSEMBLY AND ASSEMBLYTRANSMISSION OIL PUMPREMOVE TRANSMISSION OIL PUMP 3153-11start by:a) remove pilot and hydraulic pump**This operation is in the VEHICLE SYSTEMSDISASSEMBLY AND ASSEMBLY section.1.2.3.Remove bolts (1) and disconnect tube assembly(2) from the pump.Remove the bolts and disconnect tube assembly(4) from the pump.Remove bolts (3) and remove transmission oilpump (5) from the torque converter housing.INSTALL TRANSMISSION OIL PUMP 3153-121. Make sure the O-ring seals are installed in thepump body and put clean power train oil onthem. Fill the pump with clean power train oilalso.2. Put transmission oil pump (3) in position andinstall bolts (1) that hold it.3. Make sure the O-ring seal is installed in the endof tube assembly (2) and put clean power trainoil on it. Connect tube assembly (2) to thepump.4. Make sure the O-ring seal is installed in the endof tube assembly (4) and put clean power trainoil on it. Connect tube assembly (4) to thepump.end by:a) install pilot and hydraulic pump**This operation is in the VEHICLE SYSTEMSDISASSEMBLY AND ASSEMBLY section.5-213
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business