Install sleeve

Install the bolts that hold the cap and gerotor assembly

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
502

VEHICLE SYSTEMS TM 5-3805-258-24-2 DISASSEMBLY AND ASSEMBLY HAND METERING PUMP 7. 8. 9. 10. 11. 12. 13. Install six springs (17) in spool (15) with three springs on each side. Make sure the curves of the springs are in contact and in the center of the spool. The notched side of the spring ends must be toward the sleeve. Install sleeve (16) over spool (15) so the notch (slot) in the sleeve engages with the ends of springs (17). Install pin (18) in the sleeve and spool . Install sleeve assembly (19) in the pump body. Put spacer (21) in position on the pump body. Install drive (20) in the pump body. Make sure the notch (slot) in the drive is engaged with pin (18) that holds the sleeve and spool together. Install O-ring seal (23) on gerotor assembly. Install spacer (24) and gerotor assembly (22). NOTE: Make sure the gear of gerotor assembly (22) is in alignment with pin (18) as shown. 5-439

Privacy Statement
Press Release
Contact