TM 5-3805-258-24-2
VEHICLE SYSTEMS
DISASSEMBLY AND ASSEMBLY
PARKING BRAKE CHAMBER
REMOVE PARKING BRAKE CHAMBER 4353-11
1.
2.
3.
4.
start by:
a) anti-pivot link connection
Drain the air from the air tank.
Disconnect two wires (2) and air line (1) from
the quick release valve.
Remove fitting (3) from the quick release valve
and install an air fitting.
Connect shop air line (4) to the quick release
valve.
NOTE The shop air must be a minimum of 345 kPa
(50 psi).
5. Remove the cotter pin and pin (5) that holds
the lever to the yoke.
6. Remove nuts (6) that hold the parking brake
chamber on the bracket.
7. Remove the air supply from the quick release
valve.
8. Remove parking brake chamber (7) from the
machine.
5-448
