TM 5-3805-262-10
3-5. TROUBLESHOOTING TABLE (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14. TRANSMISSION OVERHEATS (CONV TEMP GAGE INDICATES IN RED ZONE) (CONT)
Step 2.
Step 3.
Stop loader operation, move transmission control lever to N (neu-
tral) position and operate engine at full throttle.
Check that CONV TEMP gage pointer moves into green zone of gage.
a. If CONV TEMP
low .
b. If CONV TEMP
operation.
Turn off engine
gage pointer remains in red zone, go to step 3 be-
gage pointer goes into green zone, continue loader
and pull up on parking brake control.
Place transmission control lever in N (neutral) position.
Move transport/service link to engaged position.
Start engine and operate at idle speed.
Unlock and remove transmission dipstick.
Check that oil level is between dipstick full and add marks.
a. If oil level is below dipstick add mark, add oil to transmission
(refer to LO 5-3805-262-12).
b. If oil level is above dipstick full mark, notify organizational
maintenance to drain excess oil.
c. If oil level is okay, install and lock transmission dipstick.
Return transport/service link to operating position.
3-25
