REMOVAL (SHEET 1 OF 2) - TM-5-3805-262-20

b. T u r n S i g n a l S w i t c h B u l b

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1078

TM 5-3805-262-20 12-1. SIGNALING DEVICES MAINTENANCE (CONT) c. Turn Signal Switch and Flasher. This task covers removal, cleaning, inspec- t i o n , r e p a i r , t e s t i n g , a n d i n s t a l l a t i o n o f t u r n s i g n a l s w i t c h a n d a s s o c i a t e d f l a s h - e r . TOOLS: No. 1 Common Organizational Maintenance Tool Kit Screwdriver Socket wrench set, 3/8 inch drive E l e c t r i c a l r e p a i r t o o l k it Multimeter MATERIALS/PARTS: Clean cloths (Appendix C, item 1) Cleaning solvent P-D-680 (Appendix C, item 2) Detergent (Appendix C, item 3) Insulation tape (Appendix C, item 5) Isopropyl alcohol (Appendix C, item 15) Tie straps, two (FSCM 53421 PN T50R0W) NOTE PRELIMINARY PROCEDURE: Battery ground cable disconnected (page 5-148). REMOVAL (SHEET 1 OF 2) (1) (2) (3) ( 4) (5) On steering column, cut, remove, and discard two tie straps (l). Disconnect light blue wire terminals (2 and 3) by grasping with fingers and firmly pulling apart. Repeat with white-blue wire terminals (4 and 5 ) . Reach up beneath right instrument panel cluster just above SHUT OFF knob, and disconnect violet wire spade terminal (6) from flasher terminal No. 2 by grasping spade terminal with fingers and firmly pulling from flasher t e r m i n a l . Remove two capscrews (7) and lock washers (8) while supporting bracket (11) and switch (12). Remove bracket and switch while carefully guiding switch wires through hole in cover. Remove two screws (9) and lock washers (10) then separate bracket (11) and turn signal switch (12). 12-8

Privacy Statement
Press Release
Contact