TM 5-3805-262-20
INSPECTION, TESTING, AND REPAIR (SHEET 2 OF 2)
( 4 ) I n s p e c t b a c k - u p a l a r m s w i t c h ( 1 5 ) f o r c r a c k s , b r e a k s , d i s t o r t i o n , or
other damage. Replace as necessary. Check for cracked or broken insula-
tion where wires just emerge from body. If any of these conditions are
seen, replace switch. Connect multimeter across spade terminals and check
f o r o p e n c i r c u i t ( i n f i n i t y ). Replace switch if multimeter indicates con-
t i n u i t y ,
( 5 ) I n s p e c t r e m a i n i n g p a r t s f o r c r a c k s , b r e a k s , d e f o r m a t i o n , d i s t o r t i o n , or
stripped threads. Replace as necessary.
INSTALLATION (SHEET 1 OF 2)
( 1)
( 2)
(3)
A t r i g h t s i d e o f t r a n s m i s s i o n , a t c o n t r o l v a l v e , i n s t a l l a n d t i g h t en
back-up alarm switch (15).
Connect wiring harness black-red wire spade terminal (13) to switch (15)
spade terminal (14) by grasping both in your fingers, alining, then
firmly pushing them together.
Connect wiring harness violet-red wire spade terminal (11) to switch (15)
spade terminal (12).
12-5
