Step 2. - TM-5-3805-262-20

3. ENGINE HARD TO START OR WILL NOT START (EXHAUST SMOKE) - TM-5-3805-262-20_278

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
264

TM 5-3805-262-20 3-30. ENGINE TROUBLESHOOTING (CONT) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 3. ENGINE HARD TO START OR WILL NOT START (EXHAUST SMOKE) (Cont). Step 2. Remove engine right side panels (page 9-14). Dry cleaning solvent P-D-680 used to clean p a r t s i s t o x i c a n d f l a m m a b l e . W e a r protective goggles and gloves and use only i n a w e l l v e n t i l a t e d a r e a . A v o i d c o n t a c t w i t h s k i n, e y e s a n d c l o t h e s a n d d o n ’ t breathe vapors. Do not use near open flame o r e x c e s s i v e h e a t a n d d o n ’ t s m o k e w h en u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o u b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a nd m e d i c a l a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u s h w i th l a r g e a m o u n t s o f w a t e r . I f c o n t a c t w i th eyes is made, wash eyes with water and get medical aid immediately. D i r t o r o t h e r f o r e i g n m a t t e r c a n d a m a ge fuel injection pump and fuel injectors and c a u s e e n g i n e s t a r t i n g p r o b l e m s . D i r t a nd f o r e i g n m a t t e r c a n e n t e r f u e l l i n e s w h en you disconnect them. To prevent this from h a p p e n i n g , c l e a n a l l f i t t i n g s , p l u g s , a nd f u e l l i n e c o n n e c t i o n s b e f o r e b r e a k i n g c o n n e c t i o n s u s i n g c l e a n c l o t h s m o i s t e n e d with cleaning solvent P-D-680. Remove plug from elbow install- ed in fuel injection pump. Install adapter (TK item 20) in elbow port from which plug was removed. Install pressure transducer (blue stripe, TK item 17) in adapter (TK item 20). Connect transducer cable W4 connector P1 to VTM J2. Connect transducer cable W4 connector P2 to transducer connector. Dial 50 into TEST SELECT. Press and hold TEST until CAL appears on display then release TEST. 3 - 2 09

Privacy Statement
Press Release
Contact