TM 5-3805-262-20
3-30. ENGINE TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
7. EXCESSIVE OIL CONSUMPTION (Cont).
Step 2.
Step 3.
Turn engine oil dipstick handle clockwise several turns then pull up
to remove.
Check if proper weight oil is used (30 weight).
a. If engine oil is not proper weight, drain engine oil, replace
oil filter, and fill engine crankcase with proper weight oil
(page 4-2) .
b. If engine oil is proper weight, go to step 3 below.
At engine oil pressure switch, disconnect wiring harness lead by
grasping with fingers and firmly pulling from switch contact. -
Remove engine oil pressure switch (page 5-112).
Install adapter (TK item 20) in port from which engine oil pressure
switch was removed.
Install pressure transducer (blue stripe, TK item 17) in adapter (TK
item 20).
Connect transducer cable W4 connector P1 to VTM J2.
Connect transducer cable W4 connector P2 to transducer connector.
3-237
