8. LOW ENGINE OIL PRESSURE.

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
295

TM 5-3805-262-20 3-30. ENGINE TROUBLESHOOTING (CONT) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 7. EXCESSIVE OIL CONSUMPTION (Cont). S t e p 6 . ( C o n t ) . e. If E013 is displayed, test data cannot be analyzed due to weak batteries or interrupted cranking during test. Correct weak bat- teries by charging them, then repeat this step. If E013 message persists, after two tests, notify next higher maintenance level to perform compression test using pressure gage. 8. LOW ENGINE OIL PRESSURE. Step 1. Remove engine left side panels (page 9-14). At engine oil pressure switch, disconnect wiring harness lead by grasping with fingers and firmly pulling from switch contact. Tell assistant to turn ignition key switch to on position and check that OIL PRESS warning light is off. Tell assistant to turn ignition key switch to off position. a. If OIL PRESS warning light is on, check for short circuit in wire between oil pressure switch and OIL PRESS warning light. b. If OIL PRESS warning light is off , reconnect wiring harness lead to engine oil pressure switch and go to step 2 below. 3-240

Privacy Statement
Press Release
Contact