TM 5-3805-262-20
4-4. COOLING SYSTEM MAINTENANCE (CONT)
c. R a d i a t o r G r i l l e.
This task covers removal, cleaning, inspection, and instal-
l a t i o n o f r a d i a t o r g r i l l e.
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Socket wrench set, 3/8 inch drive
Automotive Mechanic’s Tool Kit
S l i p j o i n t p l i e r s
Hand hammer, 2 lb
Pin, 1/8 inch diameter by 3 inches long (may be a finishing nail)
MATERIALS/PARTS: Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680 (Appendix C, item 2)
REMOVAL (SHEET 1 OF 2)
(1) At rear of loader, open radiator grille (12) by pushing handle (2) inward
and rotating clockwise or counterclockwise until rod is unlatched. Swing
r a d i a t o r g r i l l e o u t w a r d.
NOTE
Perform steps (2) through (5) below only if handle (2), spring (5), or
rod (4) require replacement.
(2) Using 1/8 inch diameter pin and hammer, drive pin (1) halfway out of
handle (2) then use slip joint pliers to remove.
4-76
