TM 5-3805-262-20DISASSEMBLY(1) Remove four screws (31), panel (32), and gasket (33).NOTEPerform step (2) below only if inspection indicates need for replacementof decal (34) or identification plate (35); otherwise go to step (3) be-low.(2)(3)( 4)(5)(6)CLEANING(1)(2)(3)Pry decal (34) and identification plate (35) from panel (32).Remove CONV TEMP gage (36), AIR PRESS gage (37), FUEL LEVEL gage (38),and WATER TEMP gage (39): carefully pull from circuit board (41) clips.Remove 13 screws (40) and separate circuit board (41) from case (42).Remove buzzer (43) bezel nut and remove buzzer from rearp a n e l.Remove voltmeter (44) from front of left-hand instrumentof instrumentp a n e l.Remove dust from all parts using clean paint brush.Clean wire insulation, lamps (3, 14, and 16), and all non-metallic partsusing clean cloth moistened with detergent. Rinse using clean clothmoistened with clean water, Dry using clean cloth.Clean terminals using clean cloth moistened with isopropyl alcohol.Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t eda r e a , A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ’ t b r e a t hev a p o r s .Do not use near open flame or excessive heat and don-t smokewhen using it. Failure to do so could cause serious injury. If you be-c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c ala t t e n t i o n i m m e d i a t e l y .If contact with skin or clothes is made, flushw i t hw i t h(4)large amounts of water.I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y e swater and get medical aid immediately.Clean all other metallic parts using clean cloth moistened with cleaningsolvent P-D-680. Dry using clean cloths.5-39
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
