TM 5-3805-262-205-4. INSTRUMENT PAN ELSMAINTENANCE (CONT)a. Left-hand Instrument Panel (cont).INSPECTION, TESTING, AND REPAIR (SHEET 1 OF 2)(1)( 2)(3)( a)(b)( c)(d)(e)Inspect socket assembly (15) wire for cracked or broken insulation orbroken wire strands at connection to terminal or socket. Repair crackedor broken insulation by applying insulation tape to area. If broken wirestrands are seen, replace socket assembly (15).Inspect wiring harness terminal (17, 20, 22, and 23) wires for cracked orbroken insulation or broken wire strands at connection to terminals. Re-pair cracked or broken insulation by applying insulation tape to area. Ifbroken wire strands are seen, cut wire as close to terminal as possible.Strip 1/4 inch insulation from end of wire taking care not to cut throughwire then crimp new terminal securely onto wire.Inspect wiring harness connector (6 and 7) wires for cracked or brokeninsulation or broken wire strands at connection to terminals. Repaircracked or broken insulation by applying insulation tape to area. If bro-ken wire strands are seen, replace terminal as follows.Remove terminal from connector (6 or 7) by prying tab using small screw-driver and pulling terminal from connector as shown below.Cut wire as close to terminal as possible.Strip 1/4 inch insulation from end of wire taking care not to cutthrough wire.Crimp new terminal securely onto wire.Aline terminal with connector (6 or 7) and push into connector untilt e r m i n a l t a b c l i c k s .5-40
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
