TM 5-3805-262-20
REMOVAL
(1)
(2)
(3)
(4)
(5)
( 6 )
(7)
(8)
CLEANING
(1)
(2)
Dry
At left front fender, loosen three screws (1) and remove door (3).
If necessary for replacement, remove three retaining rings (2) and screws
(1) from door (3).
Remove lamp (4) by pressing lamp in, turning 1/4 turn counterclockwise,
and pulling from socket.
Remove three clips (5) and pull lamp unit (6) from housing (12).
Disconnect terminal (7) and connectors (8 and 9) by grasping with fingers
and pulling firmly. Then remove lamp unit (6).
Loosen and remove nut (10) and lock washer (11).
Lift housing (12) from front fender and pull washer (13) from housing.
Inside housing (12), remove adapter (14) and grommet (15) only if neces-
sary for replacement.
Clean lamp (4), connector (8 and 9) shells, lamp unit (6), grommet (15),
and wire insulation using clean cloth moistened with detergent. Dry using
c l e a n c l o t h.
Clean lamp (4) contacts and wire terminals using clean cloth moistened
with isopropyl alcohol.
cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n ,
e y e s a n d c l o t h e s a n d d o n ’ t b r e a t he
v a p o r s .
Do not use near open flame or excessive heat and don’t smoke
when using it. Failure to do so could cause serious injury. If you be-
c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
a t t e n t i o n i m m e d i a t e l y .
If contact with skin or clothes is made, flush
with large amounts of water.
I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y e s
with water and get medical aid immediately.
(3) Clean all other metallic parts using clean cloth moistened with cleaning
solvent P-D-680. Dry using clean cloths.
5-99
