REMOVAL
TM 5-3805-262-20
CENTER DRIVE SHAFT
(a) Loosen cap located on center drive shaft (5). If necessary, use pene-
trating oil to dissolve rust holding cap in position .
(b) Remove four capscrews (1) and lock washers (2).
( c ) I f n e c e s s a r y , u s e p r y b a r t o g e n t l y s e p a r a t e c e n t e r d r i v e s h a f t ( 5 )
universal joint from front drive shaft yoke.
(d) Support center drive shaft (5) and remove four capscrews (3) and lock
washers (4). Push halves of center drive shaft together and remove
center drive shaft from vehicle .
SUPPORT BEARING
(a) Perform steps (a) through (g) of front drive shaft removal (page 6-34).
(b) Remove four capscrews (7) , nuts (8), and lock washers (9) securing
support bearing (10) to chassis .
(c) Using a hammer and chisel, loosen inner race of support bearing from
drive shaft as shown below.
(d) Remove support bearing (10) from front drive shaft and vehicle.
6-41
